5-JAN-2010It’s time to fix my 9-track tape drive, a Cipher 880. The Cipher 880 9-track tape drive installed on the DSVAX III would usually work up to the point of an “init”, but a fault would always develo Subsequently, testing the arm movement found no problem (service aid 24 found normal voltages). Thus I decided to open up the drive and check what gives. Checking the huge PCB, I found Running the tape drive open, another problem suddenly appeared – the vacuum motor was constantly “on”. Running diagnostic test No. 34 and pressing the LOAD button did not manage to switch it off either. I have tracked the problem to a faulty chip, U17P (A 7438 hex schmitt trigger inverter).
The offending IC 7-JAN-2010 U17P (7414 Hex Schmitt Trigger) Removal and Replacement
After replacing the offending 7414, the problem was solved – the suction motor is again under control. Now it is time to dig in and solve that “error code 17”. |
p.The fault is indicated by error code 17 – “LOAD” and “HI DEN” flashing, which means “The compliance arm exceeded its travel limits during normal operation”.
the components on it do not correspond to the schematics found on the 
should only have pins 5 and 6 used, but its pin 1 is connected via a long jumper wire to one of the Z8036 IC’s, meaning the schematics are not complete, perhaps this patch was part of what made this drive a F880 ? I can’t tell whether the original PCB was swapped and I am looking at a replacement from a 891, which was done long, long ago.
the pins, placed a socket instead, and mounted a new 4136. Finished off with re-doing the two resistor patch.
Status: (2017): Can mount a tape, see its label under VMS. But any attempt to read from it quickly aborts with various read errors. Need to tune the read threshold using test aid 21.